|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Pore Structure Regulation of Carboxyethylated Microfibrillated Cellulose Films显示文摘Carboxyethylation is a recent chemical pretreatment for preparation of microfibrillated cellulose(MFC).The carboxyethylated MFC film prepared by coating method has compact structure and high mechanical properties.In order to expand its application,three approaches including using organic solvents,different drying methods and cationic additives,have been adopted in this paper to enrich and regulate the pore structure of MFC film.The results show that all the approaches can improve the pore structure but decrease the mechanical properties of MFC film.When organic solvents such as ethanol,isopropanol and n-butanol were used to replace the water in MFC suspension or pre-dried MFC film,the pore structure of films were increased.Additionally,the film obtained by freeze-drying or air-drying after freezing in liquid nitrogen or freezer has high porosity but poor strength.The best drying process is to rewet dry MFC film,freeze in liquid nitrogen and then freeze-dry.Moreover,the addition of cationic polyelectrolytes or alkene ketone dimer(AKD)in MFC suspension can also significantly increase the film's porosity.Through the above approaches,the porosity of carboxyethylated MFC film can be regulated between 20% and 90%. | Meican Li Jinghuan Chen Jingang Liu Zehong Xu Yanqun Su Ruijuan Zhang Yanfen Du | 2020 | Paper And Biomaterials2020，5，2： | 5 |
| 2 | Different Kinds of Microfibrillated Cellulose as Coating Layers Providing Fiber-based Barrier Properties显示文摘In this study,we investigated the barrier properties of different kinds of microfibrillated cellulose(MFC)coating layers.The air,oxygen,and water vapor permeability,as well as the water contact angles(WCA),were measured to quantify the barrier efficacy of the applied coatings.The WCA data showed that the surfaces of MFC-coated cardboards are more hydrophilic than those of uncoated cardboards.However,different MFC coatings realize different oxygen transmission rates(OTRs)and water vapor transmission rates(WVTRs).The MFC coating derived from bleached bamboo pulp subjected to carboxyethylation pretreatment(MFCCBP)gave the best oxygen and water vapor barrier performances.The OTR of the virgin cardboard(>16500 cm^(3)/(m^(2)·24 h))decreased to 4638 cm^(3)/(m^(2)·24 h)after coating with the MFCCBP.The WVTR similarly decreased from 1016.7 g/(m^(2)·24 h)to 603.2 g/(m^(2)·24 h). | Ruijuan Zhang Yanqun Su Jingang Liu | 2021 | Paper And Biomaterials2021，6，1： | 4 |
| 3 | Eco-friendly PVA/Kaolin Clay Coating for Barrier Paper显示文摘The resistance of wood-fiber paper to water, grease, and water vapor is usually attained by immersing the base paper in hydrophobic oil, laminating with a plastic or metal film, or the application of a barrier coating. Oil impregnation and the addition of films may make the paper difficult to recycle or persistent in the environment owing to their strong binding force and nondegradability. Environmental concerns have attracted worldwide attention to eco-friendly barrier coatings. In this study, degradable polyvinyl alcohol(PVA) and kaolin clay pigment were used to prepare coatings that were applied to a base paper. By measuring the barrier properties of the coated paper, including the water absorptiveness(Cobb60 value), Hercules sizing degree, oil resistance(Kit rating), and water vapor transmission rate(WVTR), an optimal coating formulation and process were proposed. To examine the barrier mechanism of the PVA/kaolin clay coating, we characterized the coating microstructures using a scanning electron microscopy(SEM) and a mercury porosimeter. The results showed that the Cobb60 value and water vapor transmission rate of the coated paper decreased by 61.4% and 98.6%, respectively, compared with the base paper, for a pre-coating weight of 0.98 g/m^2 and a top-coating weight of about 3.23 g/m^2. Furthermore, the Hercules sizing degree rose by a factor of 337.2, while the oil resistance(Kit rating) increased from 0 to 12. The optimum drying temperature for a wet coating layer was found to be 170℃, and the optimum weight ratio of PVA to kaolin clay in the coating was determined to be 50∶50. It was assumed that the PVA/kaolin clay coating improved the smoothness of the paper considerably and decreased the pore size by filling the pores on the paper surface and forming an even film, thus enhancing the paper barrier performance. The coated paper also exhibited good repulpability. | YanFen Du JinGang Liu JiaFu Wang YanQun Su HongCai Li BiSong wang RuiJuan Zhang | 2017 | Paper And Biomaterials2017，2，2： | 3 |
| 4 | Effects of MFC-modified GCC as Filler on the Opacity of Pulp Handsheets显示文摘Microfibrillated cellulose(MFC)was obtained by mechanical grinding of different pulps.MFC-modified ground calcium carbonate(GCC)was prepared in two different ways,designated MFC-GCC composite filler and MFC-GCC flocs filler.The opacity of pulp handsheets loaded with MFCmodified GCC was measured.The effects of MFC originated from different pulps,pretreatment method,and filler modification on the opacity of handsheets loaded with MFC-modified GCC were discussed.The results show that MFC originated from alkaline peroxide mechanical pulp(APMP)was optimal for improving the opacity of the handsheets and PFI grinding pretreatment for MFC provided a denser structure in the corresponding MFCAPMP-GCC floc filler while enzyme pretreatment was more effective in increasing the opacity of the filled paper.Under the experimental conditions,the opacity of handsheets increased from 81.0%to 82.7%when the unmodified GCC was replaced by an equivalent amount of MFCAPMP-GCC composite filler,while other properties were unchanged. | Yanqun Su Junjie Liu Jingang Liu Ruijuan Zhang Jinghuan Chen Yanfen Du | 2020 | Paper And Biomaterials2020，5，3： | 3 |
| 5 | Preparation and Application of Microfibrillated Cellulose-modified Ground Calcium Carbonate显示文摘Microfibrillated cellulose(MFC) was first prepared by 2,2,6,6-tetramethylpiperidine-1-oxyl(TEMPO) oxidation pretreatment and mechanical grinding in the presence of a certain amount of ground calcium carbonate(GCC).The effects of GCC dosage and grinding concentration on the fibrillation were investigated.The obtained MFC was then added to the bulk GCC to form MFC-modified GCC fillers.The properties of MFCmodified GCC fillers were compared to those of the traditional GCC fillers.Results showed that the resulting fibrils became more uniform when the dosage of GCC was 10%~15% and the concentration of the suspension was 6.97%.Compared to traditional GCC,the average particle size of the MFCmodified GCC fillers was larger.Scanning electron microscopy images showed that GCC and MFC formed a bridge structure in the MFC-modified GCC fillers.In the process of papermaking,the MFC-modified GCC fillers decreased the drainage rate but increased the retention of fillers.The prepared papers filled with MFC-modified GCC fillers had higher tensile strength than those filled with traditional GCC fillers. | Xia Lv YanQun Su JinGang Liu | 2017 | Paper And Biomaterials2017，2，3： | 2 |
| 6 | Preparation of Ultrafine Starch Particle and its Application in Paper Coating显示文摘Despite its biodegradability, adequate cohesive strength and comparatively low cost, the use of cooked starch as a paper coating binder is limited due to its high viscosity and serious negative impact on the gloss. Starch-based bio-latex with size in the nanometer or sub-micrometer range has been developed recently to overcome these shortcomings. In this study, ultrafine starch particle(UFSP) was prepared by mechanical milling using a DYNO mill in combination with light chemical pretreatment. Model coating colors containing different dosages of UFSP were applied to base paper and the properties of the coated papers were evaluated. The results showed that the UFSP was disc-shaped with a median particle diameter of 167 nm. Water retention capacity of the coating colors was improved considerably with the addition of UFSP, i.e., the water retention value decreased by nearly 40% when styrene-butadiene latex was replaced by UFSP at a dosage of 3 pph(per hundred parts of pigment). The high shear rate viscosities of the coating colors containing no more than 2 pph of USFP were similar to that of the control coating color at shear strain rate higher than 2000 s^(-1). The properties and performances of the coated papers were comparable to the control coated paper with single synthesized latex binder. The gloss and the print gloss of paper samples with or without USFP were 59.7% and 58.2%, 79.0% and 78.8%, respectively. Surface strength of paper samples with or without USFP were 0.96 and 0.90 m/s, respectively, while the ink absorptivity values were 34% and 33%. This study demonstrates a promising approach to obtain submicrometer sized starch for paper coating. | JinGang Liu JiaFu Wang YanFen Du BiSong Wang HongCai Li YanQun Su JingHuan Chen | 2017 | Paper And Biomaterials2017，2，1： | 2 |
| 7 | Longitudinal virological changes and underlying pathogenesis in hospitalized COVID-19 patients in Guangzhou,China显示文摘Prolonged viral RNA shedding and recurrence of severe acute respiratory syndrome coronavirus 2(SARS-CoV-2)in coronavirus disease 2019(COVID-19)patients have been reported.However,the clinical outcome and pathogenesis remain unclear.In this study,we recruited 43 laboratory-confirmed COVID-19 patients.We found that prolonged viral RNA shedding or recurrence mainly occurred in severe/critical patients(P<0.05).The average viral shedding time in severe/critical patients was more than 50 days,and up to 100 days in some patients,after symptom onset.However,chest computed tomography gradually improved and complete absorption occurred when SARS-CoV-2 RT-PCR was still positive,but specific antibodies appeared.Furthermore,the viral shedding time significantly decreased when the A1,430G or C12,473T mutation occurred(P<0.01 and FDR<0.01)and increased when G227A occurred(P<0.05 and FDR<0.05).High IL1R1,IL1R2,and TNFRSF21 expression in the host positively correlated with viral shedding time(P<0.05 and false discovery rate<0.05).Prolonged viral RNA shedding often occurs but may not increase disease damage.Prolonged viral RNA shedding is associated with viral mutations and host factors. | Zhengtu Li Yinhu Li Ruilin Sun Shaoqiang Li Lingdan Chen Yangqing Zhan Mingzhou Xie Jiasheng Yang Yanqun Wang Airu Zhu Guoping Gu Le Yu Shuaicheng Li Tingting Liu Zhaoming Chen Wenhua Jian Qian Jiang Xiaofen Su Weili Gu Liyan Chen Jing Cheng Jincun Zhao Wenju Lu Jinping Zheng Shiyue Li Nanshan Zhong Feng Ye | 2021 | Science China(Life Sciences)2021，64，12： | 1 |
| 8 | Degradable Foam Tray Based on High-concentration Dispersed Cellulose Fibers Obtained by a Hot-press Baking Process显示文摘Degradable industrial packaging foam trays made from cellulose fibers were fabricated using a hot-press baking process.Bleached softwood pulp fibers with a concentration of 30%were dispersed at a high speed under the action of a dispersant.The effects of the dispersant dosage of the fibers on the porosity,foam density,and static compression characteristics were discussed.Furthermore,the effects of the reinforcing adhesive including polyvinyl alcohol(PVA),and cassava starch on the physical and mechanical properties of the foam trays were studied,as well as the relationship between these properties and the microstructure of the foam trays.The dispersant enhanced the rheological and blistering properties of the fiber dispersion.As the dispersant dosage increased from 2%to 4%,the foam density gradually increased and the compressive strain performance and residual compressive strain of the foam trays decreased.Under the condition of constant dosage of dispersant,increasing the fiber proportion from 67%to 77%improved the porosity and foam density and slightly reduced the static compression performance.In additioton,the static compression resistance of the foamed materials was improved by increasing the PVA dosage since PVA was beneficial for improving the strength of the foam trays. | Ruijuan Zhang Yanqun Su Tao Zhao Jingang Liu Hongjie Zhang Leilei Hou Xianling Fu Qi Chen | 2023 | Paper And Biomaterials2023，8，4： | 0 |
| 9 | Research Status and Prospects of Bio-based Materials for Grease Barrier Coatings on Paper Food Packaging显示文摘Increased environmental and health concerns over the use of plastic packaging or fluorine-containing coatings,in combination with increased market demand for products with a longer shelf life,make bio-based materials one of the most important research candidates for alternative paper packaging materials for oil resistance.These bio-based materials have excellent oxygen and oil barriers,which are critical for food packaging.Moreover,they are biodegradable,naturally renewable,and safe.In this artical,two main groups of bio-based oil repellents for paper food packaging,including polysaccharide-based biopolymers and protein-based biopolymers,are enumerated,and the advantages and weaknesses of bio-based oil repellents are discussed,and effective solutions are proposed.Finally,research status and prospects on the development of bio-based oil-resistant coatings for the food packaging industry are presented. | Qi Chen Ruijuan Zhang Yanqun Su Tao Zhao Qi Du Jingang Liu | 2023 | Paper And Biomaterials2023，8，4： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员