| 1 | Fast Design Method of Variable Flux Reluctance Machines显示文摘In this paper,a fast design method is developed based on a combination of analytical and finite element(FE)methods for variable flux reluctance machines(VFRMs).Firstly,the feasibility of using analytical method in optimization under unsaturated condition is confirmed.Then,by applying the FE method,the influence of magnetic saturation is considered.Compared with the unsaturated case,the optimal split ratio for magnetically saturated case is increased by 1~1.2 times,the optimal rotor pole arc ratio varies within 0.33~0.44,and the stator pole arc ratio remains the same.Based on this,the optimal structural parameters can be initially set by analytical method and then refined by the FE method.Due to the fast speed of analytical method,less variable counts and narrowed variation ranges,the proposed method is significantly faster than the conventional pure FE based global optimization.Finally,the proposed method is used for optimizing the 6-stator-slots VFRMs having different numbers of rotor poles.The 6-stator-slot/7-rotor-pole(6s/7r)VFRM is found to have the highest torque density.It is prototyped and tested to verify the analyses. | L.R.Huang J.H.Feng S.Y.Guo J.X.Shi W.Q.Chu Z.Q.Zhu | 2018 | CES Transactions on Electrical Machines and Systems2018，2，1： | 0 |
| 2 | FRICTION PROPERTIES OF OIL-INFILTRATED POROUS AAO FILM ON AN ALUMINUM SUBSTRATE显示文摘The porous anodic aluminum oxide (AAO) film on a pure aluminum substrate was pre pared by a two-step anodization in a 0.3M oxalic acid solution and pore-enlargem ent treatment in the phosphoric acid aqueous solution at 50℃. The diameter of h ighly ordered pore on the AAO film was about 90nm, and the thickness of the AAO film was 3μm. The mineral oil was infiltrated in the ordered nanometer sized po res of AAO film on an aluminum substrate due to the capillarity effect. The fric tion coefficient was measured using a ball-on-disk tribotester. The tests were c onducted at loads range from 490 to 2450mN and at sliding velocities between 0.1 and 0.5m·s-1. Oil infiltration in porous AAO film modified friction and consid erably improved the wear resistance. As compared to the porous AAO film, the oil -infiltrated specimen had low friction coefficient. With increasing the applied load and sliding velocity, the friction coefficient of the oil-infiltrated film decreased. It indicates that the oil-infiltrated AAO film produced a new way to modify the friction and wear of aluminum alloy. | C.X.Jiang J.P.Tu S.Y.Guo M.F.Fu X.B.Zhao | 2005 | Acta Metallurgica Sinica(English Letters)2005，18，3： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员