| 1 | Tailoring bimodal grain structure of Mg-9Al-1Zn alloy for strength-ductility synergy:Co-regulating effect from coarse Al_(2)Y and submicron Mg_(17)Al_(12) particles显示文摘Grain boundary strengthening is an effective strategy for increasing mechanical properties of Mg alloys.However,this method offers limited strengthening in bimodal grain-structured Mg alloys due to the difficultly in increasing the volume fraction of fine grains while keeping a small grain size.Herein,we show that the volume fraction of fine grains(FGs,~2.5μm)in the bimodal grain structure can be tailored from~30 vol.%in Mg-9 Al-1 Zn(AZ91)to~52 vol.%in AZ91-1Y(wt.%)processed by hard plate rolling(HPR).Moreover,a superior combination of a high ultimate tensile strength(~405 MPa)and decent uniform elongation(~9%)is achieved in present AZ91-1Y alloy.It reveals that a desired bimodal grain structure can be tailored by the co-regulating effect from coarse Al_(2)Y particles resulting in inhomogeneous recrystallization,and dispersed submicron Mg_(17)Al_(12)particles depressing the growth of recrystallized grains.The findings offer a valuable insight in tailoring bimodal grain-structured Mg alloys for optimized strength and ductility. | Yong-Kang Li Min Zha Hai-Long Jia Si-Qing Wang Hongmin Zhang Xiao Ma Teng Tian Pinkui Ma Hui-Yuan Wang | 2021 | Journal of Magnesium and Alloys2021，9，5： | 6 |
| 2 | An accurate loading experimental measurement device for superplastic free bulging显示文摘Superplastic alloy has very strong structure sensitivity. Superplastic bulging with a die of the plate is related not only to stress state but also closely to loading paths. It is an important basis for bulging forming with a die to study deformation law and experimental apparatus for superplastic free bulging, because the boundary of test piece is fixed and friction is insignificant for free bulging. In the paper, a pure high-pressure argon gas source is used as the loading media after it is heated by the heating system outside the furnace, which improves the heating efficiency and temperature uniformity of the test piece. The photoelectric non-contact measurement device can avoid negative influence on the additional stress and uneven temperature at the peak of bulging part caused by push rod in the contact measurement. The temperature and pressure of the test piece in cylindrical insulation furnace with blank holder give feedback control to improve the control precision. In loading gas channels, the pressure is adjusted by accurately measuring and controlling the rotation angle of the stepping motor, and is loaded by an electro-magnetic valve. It significantly increases the response characteristics of the control pressure. This paper also introduces steps and methods to realize several typical loading paths, such as constant pressure, jump pressure and additional back & differential pressure loading. These provide a new way to measure the strain rate sensitivity index m value and improve the deformation speed of superplastic free bulging. | SONG YuQuan MA PinKui GUAN XiaoFang | 2013 | Science China(Technological Sciences)2013，56，9： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员