| 1 | An air quality forecasting system in Beijing-Application to the study of dust storm events in China in May 2008显示文摘An air pollution forecast system,ARIA Regional,was implemented in 2007-2008 at the Beijing Municipality Environmental Monitoring Center,providing daily forecast of main pollutant concentrations.The chemistry-transport model CHIMERE was coupled with the dust emission model MB95 for restituting dust storm events in springtime so as to improve forecast results.Dust storm events were sporadic but could be extremely intense and then control air quality indexes close to the source areas but also far in the Beijing area.A dust episode having occurred at the end of May 2008 was analyzed in this article,and its impact of particulate matter on the Chinese air pollution index (API) was evaluated.Following our estimation,about 23 Tg of dust were emitted from source areas in Mongolia and in the Inner Mongolia of China,transporting towards southeast.This episode of dust storm influenced a large part of North China and East China,and also South Korea.The model result was then evaluated using satellite observations and in situ data.The simulated daily concentrations of total suspended particulate at 6:00 UTC had a similar spatial pattern with respect to OMI satellite aerosol index.Temporal evolution of dust plume was evaluated by comparing dust aerosol optical depth (AOD) calculated from the simulations with AOD derived from MODIS satellite products.Finally,the comparison of reported Chinese API in Beijing with API calculated from the simulation including dust emissions had showed the significant improvement of the model results taking into accountmineral dust correctly. | Benoit Laurent Fanny Velay-Lasry Richard Ngo Claude Derognat Batrice Marticorena Armand Albergel | 2012 | Journal of Environmental Sciences2012，24，1： | 9 |
| 2 | Particulate matter pollution in Kunshan High-Tech zone: Source apportionment with trace elements, plume evolution and its monitoring显示文摘Particulate matter(PM) in the Kunshan High-Tech zone is studied during a three-month campaign. PM and trace elements are measured by the online pollution monitoring, forecastwarning and source term retrieval system AS3. Hourly measured concentrations of PM_(10), PM_(2.5) and 16 trace elements in the PM_(2.5) section(Ca, Pb, Cu, Cl, V, Cr, Fe, Ti, Mn, Ni, Zn, Ga, As, Se, Sr, Ba)are focused. Source apportionment of trace elements by Positive Matrix Factorization modeling indicates that there are five major sources, including dust, industrial processing, traffic,combustion, and sea salt with contribution rate of 23.68%, 21.66%, 14.30%, 22.03%, and 6.89%,respectively. Prediction of plume dispersion from concrete plant and traffic emissions shows that PM_(10) pollution of concrete plant is three orders of magnitude more than that of the traffic. The influence range can extend to more than 3 km in 1 hr. Because the footprint of the industrial plumes is constantly moving according to the local meteorological conditions, the fixed monitoring sites scattered in a few hundred meters haven't captured the heaviest pollution plume at the local scale of a few km^2. As a more intensive monitoring network is not operationally possible, the use of online modeling gives accurate and quantitative information of plume location, which increases the spatial pollution monitoring capacity and improves the understanding of measurement data. These results indicate that the development of the AS3 system, which combines monitoring equipment and air pollution modeling systems, is beneficial to the real-time pollution monitoring in the industrial zone. | Suwei Zhang Qijie Zhang Armand Albergel Didier Buty Liangmin Yu Haiting Wang Wuxia Bi Peng Cheng Fu Chen Jun Fang Ruirui Hou Xudong Luan Changgan Shu Jingjing Su | 2018 | Journal of Environmental Sciences2018，30，9： | 3 |
您所在的机构暂未开通此部分的功能，请联系管理员